IMG 1010 - Configure GCEMS and Start Linux Services
Related Topics:
IMG 1010 - Downloading System Software
IMG 1010 - Starting ClientView - Overview
Before You Begin:
The IMG 1010 should be unpacked, mounted, and connected power to the GCEMS server. See the manufacturer's instructions for installation procedures.
The GCEMS software must be installed. See IMG 1010 - Installing GCEMS Software.
Acquire IP Addresses for the IMG 1010.
Acquire the MAC address of the IMG from tag on bottom of unit.
...
Connect to the GCEMS Server.
Login as:
user: excelsw
password: excelswIf a DNS server is needed in your network you will need to configure a DNS server. To configure DNS on GCEMS server follow next few steps.
In the RedHat GUI select System Settings > Network and the following screen below will appear.
Select the DNS tab and enter a hostname for the DNS server in the Hostname field.
Enter Primary and Secondary IP addresses for the primary and secondary DNS servers.
Close the network configuration screen.
Create link to load software from ftp server
...
| Info |
|---|
To create the Linux default dhcpd.conf file manually, see IMG 1010 - Sample dhcpd.conf. |
Enter values when prompted as appropriate for your configuration. You will be prompted for the following information: [factory defaults shown in bold]
Router/Default Gateway IP Address: [192.168.0.1]
Router/Default Gateway Subnet Mask: [255.255.255.0]
Subnet IP Address: (Router/Default Gateway IP Address - 1) [192.168.0.0]
FTP Server IP Address: (This PC IP Address) [192.168.0.100]
How many IMG systems are being configured? [1]
T1 or E1 IMG ( t/ e)? [ t]
CODEC Profile Selection
1 = LBR
2 = LBR + iLBC
3 = LBR + iLBC + wireless
| Info |
|---|
You must have a license for wireless codecs. You must also set host flags accordingly (see IMG 1010 - Vocoder Information) |
Enter CODEC profile? [2]
IMG(CTRL0)[1] IP Address: [192.168.0.102]
IMG(CTRL0)[1] MAC Address: (MAC shown on IMG Label) [00:20:1C:xx:xx:xx]
IMG(CTRL1)[1] MAC Address: (MAC shown on IMG Label +1) [00:20:1C:xx:xx:xx+1]
...
| Code Block |
|---|
# mv ntp.conf /etc |
See IMG 1010 - Sample ntp.conf File
Start the services nfs, vsftpd, dhcpd, and ntp
...
Once these services are running and the IMG software build is available the software can be downloaded. See IMG 1010 - Downloading System Software
CRON Jobs
The GCEMS includes a crontab that manages the GCEMS processes. This crontab runs automatically when the GCEMS is started (StartGCEMS), and stopped when the GCEMS is stopped (StopGCEMS). This file should not be edited.
...