...
This IMG 1010 Quick Start Guide is an abbreviated guide which describes how power and network cabling are connected prior to configuring. From there, the guide describes installing system software and GCEMS software. Once procedure is completed, the IMG system will be ready to start the configuration process. For more in depth information on installation and setup, refer to the online documentation at IMG 1010 Documentation
Shipping Information
Review the packing list to check that all the items listed on the packing list have been sent. Should any discrepancies exist, contact your Sales Representative immediately.
...
For more information regarding AC Power, please refer to IMG 1010 - Connecting AC Power.
Connecting DC Power
If the IMG 1010 is powered by DC voltage, the DC input power must conform to the specifications in the table below.
...
For more information regarding DC Power, please refer to IMG 1010 - Connecting DC Power.
Grounding (DC Version Only)
...
For more information regarding DC Power, please refer to IMG 1010 - Connecting DC Power.
Network Connections
Connecting CTRL 0 Interface
...
Connect the cables as shown in the figure below. The figure below displays the DATA 0 interface being connected to a public network.
The DATA 0 interface located on the rear of the IMG 1010 and is a Gigabit-Ethernet port dedicated to VoIP Bearer traffic (RTP) or SIP/H.323 signaling. Refer to the the topics under the IMG 1010-Installation and Setup Guide > IMG 1010-Hardware Installation book for more information on connecting to this interface.
| Info |
|---|
The IP addresses for these ports are assigned through the ClientView GUI. For more information on configuring these interfaces, refer to the IP Address and IP Network (Interface) topics in the IMG 1010 - ClientView Pane Reference section of the online documentation. |
...
The Bearer spans (Interface Offsets) 0-27 are connected to a TDM network. Each bearer interface which represents one DS1 can have signaling and/or bearer DS0’s configured on them. The Signaling/Timing interfaces can be connected to the TDM network as well. These interfaces are typically used for SS7 or ISDN signaling but can be used for any TDM functionality as well. Refer to IMG 1010 - T1-E1 for more information.
| Info |
|---|
SS7 Signaling links and ISDN D-channels can be brought in over either the Signal/Timing Ports or the Bearer Ports. |
...
| Info |
|---|
If the GCEMS server was not purchased from Sangoma, then a server must be configured with Red Hat Enterprise Linux. The GCEMS and ClientView applications use Red Hat Enterprise Linux as the operating system to run on. In the online documentation, the topics under IMG 1010 - Linux Installation display recommended GCEMS server specifications, recommended Linux Configuration and OS settings, and one example describing the installation of Red Hat Enterprise Linux onto a server. Follow these topics to install Linux on a server. Once Linux is installed, continue on with the procedure below. |
...
Once these services are running and the IMG software build is available the software can be downloaded. Refer to IMG 1010 - Downloading System Software and download the system software from the GCEMS server to the IMG 1010.
...
For more information on installing GCEMS and ClientView refer to IMG 1010 - Installing GCEMS Software.
Starting ClientView to start Configuring Switch
...