Page Comparison

...

• Create a Logical IMG object. See IMG 1010 - Logical IMG for more information.

• Create a Physical IMG object. See IMG 1010 - Physical IMG for more information.

• Right Click on ‘IMG Name:’ and select New Network. A network pane will appear. No configuration needs to be accomplished here. This object will allow for multiple IP objects to get created below it. See IMG 1010 - IP Network (Interface) for more information.

• Right Click on IP Network and select New Logical Interface. The following ClientView Object Pane will appear. Configure the Data interface. See IMG 1010 - Logical Interface for more information.
  

  Image RemovedImage Added

  • Interface- In this example Data was selected from drop down menu.

  • Probe Detection (Default = Disabled)- To enable Smart Probing feature on the DATA 0/1 select Enabled from drop down list.

  • Probe Interval – Select from drop down menu number of seconds.

  • Probe Threshold – Select from drop down menu number ARP requests IMG will send before initiating a switchover from interface Data 0 to Data 1

• Right Click on Logical Interface and select New Probe Endpoint. In the object pane that appears, click in the IP address field and enter the IP address of the endpoint that the IMG will sent ARP request packets to. Up to three separate endpoints can be configured. See IMG 1010 - Probe Endpoint for more information.

• To give the Data Port an IP address, right click on IP Network again and select New IP Address. See IMG 1010 - IP Address for more information.
  

  Image RemovedImage Added

  • Physical Interface – Select ‘CPU’ from drop down menu.

  • Logical Interface – Select the interface that the Ethernet Link Redundancy Via Smart Probe will be configured on. In this example, Data was selected.

  • Address Type – IMG supports IPV4 only.

  • IP Address- IP address that will be assigned to this port. Click in the IP address field and enter IP address in box that appears.

  • Subnet Mask (Default 255.255.255.0)- Enter subnet mask. Click in the Subnet field and enter IP address in box that appears.

  • Default Gateway – IP address of the Default Gateway this interface will connect to.

  • Gratuitous ARP and ARP Responses – Leave as enabled
     

...