...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
A factory reset of your Vega Gateway should only be performed if you have lost log-in credentials or is not performing correctly.
...
Log into the Vega Gateway WebGUI and select System from Expert Config
Click on the Update License button
You will be presented with the License screen details. Circled in red is where your license key is located.
Copy and paste this string of characters as you will need it again to install back your license
Command Line Method
Connect your Vega to a PC through the serial port with the Vega console cable
Use a terminal console application (ex. Putty or Hyper Terminal), set the following:
Serial port settings
speed 115200
Data bits 8
stop bits 1
Parity None
Flow Control XON/XOFFLog into the Vega CLI with your login credentials
In the Vega CLI type upgrade, then license
as seen above, your license file will be presented. Copy and paste the entire string above somewhere safe to be used again after the reset is complete.
...
Connect your Vega to a PC using the console cable that was shipped with your Vega
Depending on your Vega, the console cable shipped will be either one of the following
  |
b. Plug the RJ45 end of the console cable into the Console port on the back of the Vega Gateway
...
Log into the Vega Gateway WebGUI and select System from Expert Config
Click on the Update License button
Paste the license key (which you have saved) into the text box, as seen in the below diagram
Click Submit when done
...