...
...
...
The following describes how to configure a Vega 50 BRI to connect your Legacy PBX to an ITSP
...
Log into the Vega gateway using the WebUI interface. The default user is admin and password is admin
The 'Status' screen will begin to load. Once the page has loaded select the "Quick Config" menu option as shown below
The WebUI will present a warning message please read the message and then select "Continue" on the screen below
Once the Quick Config UI has loaded select the "Basic" Tab.
Country - Changing the country configuration may require the current changes to be re-submitted to the Vega and may result in the Topolgy being changed from E1 to T1.
This is where the Country localisation and IP address configuration is specified.
| Info |
|---|
You must specify the correct Country for the Vega to use the correct BRI topology and for the correct network tones to be configured |
...