Asterisk D100 Single Server Installation
...
*A manual firmware upgrade is required to use the above 1.2.x releases for cards
purchased before November 10th, 2010
--> Firmware upgrade Procedure
...
Transcoding Package Downloading & Installing
...
Configuring the Ethernet device
Info |
---|
Note this step is distro-dependent |
To Configure the network interface (RedHat/Fedora/CentOS-5.x)
...
Asterisk Sangoma Transcoding Config file:
/etc/asterisk/sangoma_codec.conf
Transcoder Hardware Configuration file:
/etc/sngtc/sngtc_server.conf
If you have more than one D100 on the network "sngtc_server.conf" will only list information of the first D100 detected (i.e IP address). The rest of the D100 configurations are hidden and will use consecutive IP addresses. (i.e first D100- 10.1.1.150, second D100- 10.1.1.151, third D100- 10.1.1.152...)
If the server has more than one Ethernet interface connected to the network, "sngtc_server.conf" will list all Ethernet interfaces that have detected the D100(s) and populate the exact same information in each EthX tag
Asterisk now needs to be configured to load the "codec_sangoma" module each time it starts.
...