...
| Warning |
|---|
The procedure below assumes a familiarity with the general terminology associated with electronic equipment and with safety practices and regulatory compliance required for using and modifying electronic equipment. The procedure below should be performed by qualified technical personnel only. Unplug the equipment before performing the procedures described below. Failure to disconnect the power before you open the chassis can result in personal injury or equipment damage. The power supply in this product contains no user-serviceable parts. Refer servicing to qualified technical personnel only. |
Procedure
Update MAC address (DHCP only)
| Info |
|---|
If using an SD Card, simply remove the card from the old motherboard and place it in the new one and skip this section. If using DHCP, you must update the MAC address in dhcpd.conf. |
...
Locate both MAC address entries for the old motherboard. Change each MAC address to the corresponding address for the new motherboard.
Save dhcpd.conf file.
Remove existing tray.
AC Chassis
Set power to OFF (O) at rear of docking station.
Loosen the two ejector captive fasteners located on each side of the front panel.
Lift the ejectors upward and pull to unseat tray from docking station.
Slide tray completely out. If returning the tray to Sangoma, contact Sangoma Technical Support.
DC Chassis
The DC tray is hot swappable so there is no on/off switch on rear of panel.
Loosen the two ejector captive fasteners located on each side of the front panel.
Lift the ejectors upward and pull to unseat tray from docking station.
Slide tray completely out. If returning the tray to Sangoma, contact Sangoma Technical Support.
Install New Tray
Align rail on each side of the tray with the guides on the inside of the docking station.
Ensure the ejectors are in the up position.
Slide the tray in until the power connectors and signal connectors initially mate. The ejectors will start to move down
...