Table of Contents
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
The installation of the Multi Node system requires first installing the EMS software onto either a Virtual Machine or a Linux Server that has been pre-loaded with Red Hat Linux Enterprise 6.2. Once the EMS software has been loaded and installed, the IMG 2020 can be racked and system software can then be downloaded to the IMG 2020. The instructions below guide you through the process required to remove the IMG 2020 from shipping box, install the unit into a rack system, and load both EMS and system software. Once completed, the IMG 2020 will be ready to start configuring using the Web UI.
...
The IMG 2020 is shipped without software loaded. Obtain the latest version of software from Sangoma BBS (Bulletin Board System). Follow the instructions below.
Obtain system software from Sangoma BBS (Bulletin Board System) |
|---|
Virtual Machine Image BDN 2.3.0.xxx Host Version xxx (xxx=build and version number) System Software bdn2020_ver230xxx_id0201.bin (xxx=build number) EMS Software bdn2020_host_ver230xxx.bin (xxx=build number) |
Load Host Based Software
When running multiple nodes using one browser and Web UI application, the Dialogic EMS software must be loaded and running. The EMS software communicates with both the Web UI application and the IMG 2020 nodes. The EMS software is the link between these two entities.
...
| Info |
|---|
Sangoma also can supply a server already configured with the EMS software pre-installed. If this server has been purchased, the EMS Server - Installation and Setup procedure above can be skipped and all that would be required would be to install the system software into each of the individual IMG 2020 nodes using one of the methods in the table below. If the server was purchased but the software needs to be upgraded, refer to the topic for information on upgrading the EMS software. |
Loading Software and Configuring IP Information
After installing the Virtual Machine or EMS Server, a version of system software must be loaded into each IMG 2020 node. Refer to one of the methods displayed in the table below to load the system software.
Method | Description |
|---|---|
SD card | Load the SD Card with software and IP information prior to powering on the IMG 2020. This technique is primarily used when the IMG 2020 is at a remote site and neither FTP nor BootP access is attainable. For more information refer to Software Install - SD Card. |
SD card and FTP Server | Load the SD Card bootup.cfg file with IP information for both the IMG 2020 and the FTP server. The bootup.cfg file configures the IMG 2020 with IP information and provides information needed to obtain system software load from an FTP Server. For more information refer to Software Install - FTP/SD Card. |
DHCP/FTP Server | In the DHCP/FTP method, a dhcpd.conf file on the Server is loaded with information of where the FTP system software is located. In this method, the MAC Address of the IMG 2020 is used in the dhcpd.conf file. For more information refer to Software Install - FTP/DHCP topic. |