...
*A manual firmware upgrade is required to use the above 1.2.x releases for cards
purchased before November 10th, 2010
--> Firmware upgrade Procedure
...
Hardware Installation
Mount your transcoder
-> D150-ETH-Find a free PCI slot insider a server to install
-> D150-BOX- Find a well ventilated flat surface, or install in optional rack mount
---------Attach Power supply
-> D150-ETH- use molex power from server power supply 2A @ 5V (10W),
or external power supply 2A @ 5V (10W)
-> D150-BOX- external power supply 2A @ 5V (10W)
---------Plug the Ethernet cable into your transcoder to attach to your network
* Note: There is no on-board Ethernet switch on the D150, so once plugging in the Ethernet Cable, there is direct access to the transcoding module
...
*Note: This step assumes FreeSWITCH is on the same server as the server hosting the sngtc_server. If FreeSWITCH only exists on other server(s) please go to -> D150 sngtc server configuration
The Sangoma FreeSWITCH codec is part of the FreeSWITCH git repository. It can be easily attained by running the following command in linux CLI:
...
By default G729 is the only codec registered with FreeSWITCH. If you require additional codecs please go to the FreeSWITCH Codec Configuration page
...
Operation
The sngtc_server needs to be started before transcoding can be done. Below is the usage of the sngtc_server_ctrl command.
...
*Note by default this script is started on system boot.
To enable FreeSWITCH to connect to the sngtc_server and then to the transcoder you will need to have the module mod_sangoma_codec loaded. To load the module run the command below.
...