...
*A manual firmware upgrade is required to use the above 1.2.x releases for cards
purchased before November 10th, 2010
--> Firmware upgrade Procedure
...
Hardware Installation
Mount your transcoder, then boot the server
-> choose a server in your network and install the D500 in the PCI Express slot*Note: -> The PCI Express slot will server to provide power to the D500, where RTP traffic will flow through the LAN connection
-> An extra Ethernet interface may be brought up if your server has a Broadcom tg3 driver installed. Run "ifconfig" to verify. Disregard this extra interface (bring it down if necessary) as this interface is only used when using PCI Express Single Server installation.---------
Plug the Ethernet cable into your transcoder to attach to your network
...
*Note: This step assumes FreeSWITCH is on the same server as the server hosting the sngtc_server. If FreeSWITCH only exists on other server(s) please go to -> D500 LAN Distributed sngtc server configuration
The Sangoma FreeSWITCH codec is part of the FreeSWITCH git repository. It can be easily attained by running the following command in linux CLI:
...
This command will show each vocallo configured settings