...
We need to log into the pbx and go into System Admin and make sure that under provisioning protocols that we set HTTP Authentication to Both.
We should also note the Http username and password listed below the above section.
...
Next step is to log into Endpoint Manager and we want to create a new template for the model phone in question.
Once we have the brand of phones set we can create templates as shown below.
We also need to create extensions and we would want to make sure we have the mac address for the phones that will be associated with the extensions.
...
We will go into the extension module edit / create a new extension and fill in all information then navigate to the other tab within the extension and
Once you're in the other tab select brand / template and phone model and enter the MAC address of the phone you plan on using.
After the above has been completed you can do one of two things. you can now log into your non sangoma phone and put in the sip credentials to register the phone based on the manufacturer. For a list of supported phone models and how to configure you can go to the following link
For Sangoma phones you can setup the redirection / zero touch provisioning by doing the following.
...