...
Go to your gateway IP address
Enter your username and password
Click on Settings and Configuration
Click on T1/E1
General Settings
...
Locale
Your locale. This will be used for the tone style used when in-call indications need to be generated such as ring back, busy, congestion, and other call-oriented inband tone signals.
...
Click on the tab for the port you wish to configure.
...
Interface Type
T1
...
Set your Framing and Coding to a valid pair. This information is usually provided by the provider. Most commonly this will be ESF/B8ZS
...
These items can typically be left alone
Signalling
...
Line Signalling
This should be set based on your line configuration.
...
Setting signalling to a different mode will change the summary.
...
Signalling Role
This is for PRI and will be grayed out in other signalling modes. This is typically set to customer side when interfacing with a carrier. If you want to emulate a carrier you would set this to Network Side. This is the equivelent of pri_cpe or pri_net
...
Now back in our port settings the summary will be updated.
...
Advanced Signalling
These items may typically be left alone.
...