...
| Info |
|---|
The possibility to password protect the provisioning is available in the "System Admin Pro" module only. It is already is included in PBXact. |
...
5. By now you should boot/reboot your Sangoma s series phones. Right after the booting process is completed, your phone should display a "Login Int" and/or "Login Ext" HotDesking PhoneApp button(s) on the top left of the screen as follows (example taken from an s705):
...
| Info |
|---|
PhoneApps are supported on the s305 s series phones up to the s705 . For s206 and s300 phones, since they do not support PhoneApps, you will rather need instead to create Extension Mapping in your IP-PBX instead, prior to booting/rebooting those phones so that they get provisioned. |
| Info |
|---|
Please note that using the "Login Int" and/or "Login Ext" HotDesking PhoneApp button(s) is just one way for provisioning the phones that support PhoneApps. Another way, as mentioned above, is through Extension Mapping; if you chose to rather go that way, please skip steps 5 and 6 and follow that wiki article instead. |
6. Just press the corresponding Login soft button, depending if your phone is within the same LAN the IP-PBX is located (Login Int) or if it reaches the IP-PBX via a WAN/Internet interface (Login Ext). You will then be required to authenticate: as the 'Extension' just enter the extension number you want to provision that phone with, and, as the 'Password', that extension's voicemail password; if that extension does not have voicemail enabled, then use the "Phone Admin Password" or the "Phone User Password" defined in the Global Settings of the EndPoint Manager (see Pre-requisite III above).
...