...
Parameter | Value |
| Description |
CARD_TYPE | AFT |
| Define AFT card type |
AUTO_PCISLOT | YES |
| Enable/Disable AUTO PCI detection. This parameter can be set to YES only if you have only one card of the same type. If this option is enabled, PCISLOT/PCIBUS options are ignored (NOTE: A101/A102/A104/A108 T1/E1 is treated as the same card). |
PCISLOT |
|
|
|
PCIBUS |
|
|
|
FE_MEDIA | T1 |
| Front End Media type. |
FE_LCODE | B8ZS | T1 | Front End Line Coding. |
FE_FRAME | ESF | T1 | Front End Framing. |
FE_LINE | Number | T1/E1 | Front End Port/Line number. |
TE_CLOCK | MASTER |
| T1/E1 clock source. |
TE_REF_CLOCK | Number |
| T1/E1 Reference clock source. |
TE_HIGHIMPEDANCE | YES |
| Enable/Disable RX High Impedance mode. |
TE_RX_SLEVEL | 120 | T1/E1:12dB | Define T1/E1 Receive sensitivity (Max Cable loss allowed) (dB). |
LBO | 0DB | T1 | Define the Line Build Out (LBO compensates for the loss in decibels based on the distance from the device to the first repeater in the circuit. A longer distance from the device to the repeater requires that the signal strength on the circuit be boosted to compensate for loss over that distance.) |
FE_TXTRISTATE | YES |
| Enable/Disable T1/E1 Tx Tri-State mode. |
MTU |
|
|
|
TDMV_SPAN | Number |
| Define span number for this device |
TDMV_DCHAN | Number |
| Set to 0 if HW DCHAN is disabled. To enable HW DCHAN support, set it to dchan number |
TDMV_HW_DTMF | YES |
| Enable/Disable Hardware DTMF detection (Echo Cancellation module is required) |
TDMV_HW_FAX_DETECT | YES |
| Enable/Disable Hardware Fax detection (Echo Cancellation module is required) |
TE_IGNORE_YEL | YES |
| Ignore incoming Yellow alarms and do not stop transmitting. Needed for ATM systems where Yellows don't clear till cells are aligned |
HWEC_CLKSRC | YES |
| Changes the port that will be used to recover a clock for the HWEC. By default the first port started is used. |
...