License Installation
...
...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Introduction
This document will detail the step by step procedure used to apply a new license key to a Vega gateway.
This procedure applies to both upgrades and replacing reset license keys. This procedure is applicable for all models of Vega gateways.
In order to activate a new license a reboot of the gateway is required. This will can be scheduled to avoid disconnecting any active calls, but new calls will not be possible until the reboot is complete. Typical reboot time is 1-3 minutes.
Process
First log into the gateway, the first page shown will be the Status page:
From the Status page locate the Show button for the License Information:
Select the License Information "Show" button, this will load a new web page:
Copy the new license key and paste into the "Enter New License Key" field and select the "Submit" button:
After the license key has been applied the gateway will show a new screen confirming the License key has been applied,
please select the Click Here link from the page
Now the key has been accepted the gateway will need to be rebooted for the new license key to take effect.
The reboot can be scheduled to complete when there are no calls on the system to minimise impact on service.
Please select the Highlighted Reboot system Side menu button
...
For more information or more help please see the Sangoma's technical support website @ VEGA Gateways
Or contact your authorised Sangoma partner.
...