IMG 1010 - Replacing a Fuse

Complete the following steps to remove and replace the fuse.

...

Warning

The procedures below assumes familiarity with the general terminology associated with the electronic equipment and with safety practices and regulatory compliance required for using and modifying electronic equipment.
These procedures should be performed only by qualified technical personnel.
Unplug the equipment before performing the procedures described below. Failure to disconnect the power before opening the chassis can result in personal injury or equipment damage.
The power supply in this product contains no user-serviceable parts. Refer servicing to qualified technical personnel only.

Important Notes

Replace the fuse with a Sangoma-supplied fuse or equivalent only:
IMG 1010: 3 Amp; Slow Blow, type 3AG.
For safety, the integrated fuse can only be replaced when the power cord is removed.

Ensure the power switch on the AC power module is set to O (Off).
Unplug AC power cord.
Using a small flat bladed screwdriver, open the hinged fuse cover.
Remove the fuse holder using the screwdriver and replace fuse in holder. The fuse only mounts on one side of the cartridge.
Install the fuse holder into the AC power module with the fuse facing down.

...