...
You will need a USB keyboard, a USB mouse, and a monitor with a VGA or HDMI connections to access the console interface of Switchvox so that you may configure the network settings.
...
Attach the equipment to the appropriate Switchvox interfaces, then power on your Switchvox appliance. Once the appliance has finished booting, follow the instructions shown on the monitor.
...
...
You will be prompted to configure the network settings. If you want to proceed, select OK by pressing the 'Enter' key.
...
Once the update has finished, you will be presented with a message that the configuration was completed successfully. Select OK to continue.
...
You will be asked to select your language for the web interface. Use the up and down arrow keys to toggle between the options or select the corresponding number. Your choices are:
...
Configure Network Settings - takes you through the network settings procedure if you need to make changes.
Set Admin Password - if you forget your admin password, you may reset the admin password to its default, which is 'admin'.
Reboot the PBX
Shutdown the PBX
Reset the HTTPS Certification
Restore Web Admin Access
Set Language
Allow Tech Support Access
Unlock Local IPs - if Switchvox blocks your local IP address, this will unblock your address.
...
To access these options, use the up and down arrow keys, or click on the number associated with your option, then select Submit.
...
Finally, you will be prompted to register your Switchvox appliance. See the Switchvox Registration Admin Training article for more info.