...
The changes made in the Configuration section of the WebUI are only stored one the scratch disk.
User User MUST proceed to Apply page in the Management Section to save new configuration
...
It is not necessary to apply the configuration changes immediately every time you make them.
You You can go around the web interface making all the changes you need and then only apply them at the end when you’re ready to test them or deploy them.
Most of the configuration changes require a service restart, however, certain modules such as as, Call Routing
...
and Domain Users
...
, allow you to apply the configuration changes without restarting the NetBorder Session Controller service.
Configuration / Apply Options
The Apply section will inform the user what changes were made on the SBC.
It will also inform the user how the SBC will be affected when the configuration is applied.
...
Re-loadable Configuration
Restart Configuration
Re-loadable Configuration
*Any changes in Reload Configuration section will not affect active calls on Apply
You will see a button such as “Apply Call Routing”, which then applies the call routing changes without requiring a restart of the service and the changes will be taken by the running service instead immediately.
Restart Configuration
!Any changes in Restart Configuration section WILL bring down all sessions on the SBC.
Because SBC will Because SBC will have to be restarted for configuration to take effect.
...