Software Install Overview (Single Node)
The single node software installation requires loading system software into the IMG 2020 using one of the methods described below. The instructions below guide you through the process required to remove the IMG 2020 from shipping box, install the unit into a rack system, and load software. Once procedure has been completed, the IMG 2020 will be ready to start configuring using the Web GUI.
...
Method | Description |
|---|---|
SD card | In the SD Card method, both the system software and IP information are taken from the SD Card. This method is primarily used when the IMG 2020 is at a remote site and neither FTP nor BootP access is attainable. For more information refer to Software Install - SD Card. |
SD Card/FTP Server | In the SD Card/FTP Server method the SD Card is loaded with information required to communicate with an FTP Server. The FTP Server then loads the system software from a specific FTP directory on the FTP server. In this method a bootup.cfg is loaded with the FTP Server information. For more information refer to Software Install - FTP/SD Card. |
DHCP/FTP Server | In the DHCP/FTP method, a dhcpd.conf file on the Server is loaded with information of where the system software is located. In this method, the MAC Address of the IMG 2020 is used in the dhcpd.conf file. For more information refer to Software Install - FTP/DHCP topic. |