Page Comparison

...

1. Linux PPPD daemon

   1. PPPD Release  ........................pppd-2.4.7.tgz

2. Sangoma AFT A101/2/4/8 T1/E1 Cards

...

Wanpipe Installation

1. Download latest STABLE wanpipe release
   -->wanpipe-7.0.20.6.tgz

2. Untar wanpipe release
   --> tar xfz wanpipe-<ver>.tgz

3. Install wanpipe release
   --> cd wanpipe-<ver>
   --> ./Setup install 
         Use all default options

4. Confirm successful install
   --> wanrouter version
   --> wanrouter hwprobe

...

• wanpipemon utility

  • wanpipemon <enter> for help

• T1/E1 Alarm Statistics

  • wanpipemon -i w1g1 -c Ta

More Info

• Troubleshooting & Diagnostic commands

...

Sample Cisco 1600 Setup

 
 This This example setup should be given to an ISP that doesn't
know how to setup up Mulitlink PPP on a Cisco box :)

...

                Cisco>enable
                Cisco>password: <enter password>
                Cisco#

2. Configure Global Mulitlink PPP protocol

                Cisco# config
                Cisco(config)# multilink virtual_template 1
                Cisco(config)# exit

3. Configure Serial0 device for Multilink PPP

                Cisco# config
                Cisco(config)# interface serial0
                Cisco(config-if)# encapsulation ppp
                Cisco(config-if)# no ip address
                Cisco(config-if)# ppp multilink
                Cisco(config-if)# no shutdown
                Cisco(config-if)# exit

4. Configure Serial1 device for Multilink PPP

                Cisco(config)# interface serial1
                Cisco(config-if)# encapsulation ppp
                Cisco(config-if)# no ip address
                Cisco(config-if)# ppp multilink
                Cisco(config-if)# no shutdown
                Cisco(config-if)# exit

5. Configure virtual_template interface

                Cisco(config)# interface virtual_template 1
                Cisco(config-if)# encapsulation ppp
                Cisco(config-if)# ip address <local ip> <netmask>
                Cisco(config-if)# ppp multilink
                Cisco(config-if)# exit
                Cisco(config)# exit

...