...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
Sngtc Server Configuration
The sngtc_server is at the heart of the transcoding environment. It interfaces the transcoder hardware and codec module (the codec module, in asterisk, communicates with the sngtc_server in order to pass information to/from transcoder). It is installed only on one server, and controls all Sangoma transcoders that are located on the same network (this means you cannot have multiple sngtc_servers controlling/communicating with specific transcoders/modules on the same network). If there is more than one Sangoma transcoder on the network, the sngtc_server will access all transcoding resources in round-robin.
...
| Info |
|---|
*NOTE: the above configuration is required to be performed only one time, for the multiple server environment |
...
Routing Configuration
Now that the sngtc server is setup for your distributed network, it is important to make sure that you have IP Forwarding enabled on the machine hosting the sngtc_server, so that packets their destination without being denied by permissions.
...
run the following command to enable changes:
-> sysctl -p /etc/sysctl.conf
or
-> service network restart on Redhat distributions
->/etc/init.d/procps.sh restart on Debiun/Ubuntu distributions