...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Description:
In software 10.5.2 ER1 the IP Address object was added to replace the Network Interface object. If using software version 10.5.2 CI or an earlier version of software then use Network Interface object. The IP Address object is used to configure each of the individual interfaces (Control, Data, or Signaling) located on the rear of the IMG. Within this object the ip addresses of the interface, the subnet of the interface, and the Default Gateway can all be configured. To create the IP Address object, Right Click on the IP Network object and select New IP Address. See information below.
...