...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
This guide provides a comprehensive step-by-step instruction for upgrading the firmware on your Vega appliance.
The firmware update instructions apply to all Vega Gateway models and firmware versions.
The DSP firmware update instructions apply to only Vega firmware 11.1 and highergateway.
Review current Vega Version
Determine Use the firmware version web interface of your Vega Appliance
version can be found from the home page after logging in to the Vega
gateway to confirm the model type and current firmware version. This will help ensure you select the correct firmware for your device.
...
Download Vega Firmware Release
Download the required firmware release for your product device from the the Firmware Download Page
Upgrade Vega Firmware via GUI
...
Download the firmware for your Vega from the chart in step 2 to a location of your choice
...
Unzip the file downloaded and extract the.absfile(i.e. VEGAEURO_RO88S025.abs). For Vega200G extracted file is.bin.
The .abs/.bin file is the actual firmware file that will be used.
...
Navigate to the Vega homepage via a web browser of your choice. Then click on "system" located under "Expert Config" on the left panel
...
Click on the "Update" button located underneath the Upgrade section
...
Browse for the firmware file that you have saved from Step 3 and upload ( i.e.VEGAEURO_R088S025.abs) then click on the "Download" button:
...
Extract all contents of the firmware ZIP file package
The gateway firmware file will have a .bin extension and it will not have DSP in the filename. For an example “VEGAIMX_R131S010.bin”
Once the firmware file is located go to Expert Config -> System in the webUI
...
Click the Upgrade Firmware button
...
The prompt shown below will ask if you would like to save your Vega’s configuration. Press OK to download the file and it will take you to the firmware upgrade page
...
At the firmware upgrade page browse for your firmware file (.BIN) and press the upload button to start the upgrade
...
Once the upgrade is complete the Vega gateway will display the message below. The unit may reboot more than once.
...
Upgrade DSP if required
After the upgrade the system may prompt for a DSP upgradecheck the status page to see if the DSP requires updating. In the screen shot below the DSP status is FAILED, this means the DSP requires updating. In this case please follow the instructions on the the DSP Upgrade Page
If the DSP status is ACTIVE then you do not have to upgrade the DSP and the firmware update is completed.
...