| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
To enable the IMG 2020 to function over an IP network the network interfaces on the rear of the IMG 2020 must be configured to pass data. There are two steps involved in configuring the network interfaces. The first step is to configure one or more IP addresses to pass data through a specific interface. Second would be to specify whether the IP address would be used for RTP data or Services data such as SIP signaling, DNS Services, RADIUS, and SNMP. Below is a screen captures of the rear panel of the IMG 2020 and its respective IP Interfaces. Once the interfaces on the rear panel are configured, they can be used to pass the specific type of data it is configured for. The information below describes the steps needed to configure the network interfaces for either RTP or Services.
...