Versions Compared

Old Version 4

changes.mady.by.user Kelli Higdon

Saved on

compared with

New Version Current

changes.mady.by.user Kelli Higdon

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents
minLevel1
maxLevel6
outlinefalse
stylenone
typelist
printablefalse

...

  • Power - DC Power connector.

  • E1/T1 Port 1-2 - RJ45 port used to connect your E1/T1 Cable 

  • LAN Port 1/LAN Port 2 - RJ45 ports used to connect your LAN cables. These are Gigabit compatible ports.

    • Console - Used for diagnostics. Console cable plugs into this port

 

Info

Port 1 is configured for CPE/TE. This port is typically connected to Telco as it is set to receive the clock from the remote side
Port 2 is configured for NET/NT. This port generating clock signal and is typical connected to another PBX
If you wish to change the configure of the ports (i.e. port 1:NET/NT or port 2: CPE/TE) you must connect a cross-over cable.  (there is no software configurable pin-switching)

...

  • Power - DC Power connector.

  • Analog/BRI Ports - porst used to connect analog/bri cables 

  • LAN  1/LAN 2 - RJ45 ports used to connect your LAN cables. 

    • Console - Used for diagnostics. Console cable plugs into this port

   

...

Vega 5000

Front Panel of Vega 5000
 

...