| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
DSP Upgrade Procedure
DSP Upgrade Procedure can be achieved via three different ways:
DSP Upgrade Via GUI
DSP Upgrade Via CLI
DSP Upgrade Via AutoExe (automated)
DSP Upgrade Via GUI
The DSP can only be upgraded when required by the Vega firmware, as each Vega firmware is paired with a specific DSP firmware version.
...
Once the upgrade is complete, the DSP status will display as ACTIVE, indicating that the DSP is running the correct firmware.
...
DSP Upgrade Via CLI
DSP firmware can be upgraded via CLI also.
...
If Upgrade is successful VEGA will prompt success information over VEGA CLI as shown below:
...
DSP Upgrade Via AutoExe
In order to Upgrade DSP Firmware user have to add the above list of CLI commands as explained in Upgrade Via CLI section in to their respective AutoExe script.
...
| Info |
|---|
NOTE: In order to achieve DSP ACTIVE user must have to Upgrade to respective VEGA Firmware version on which respective DSP firmware version is supported to which user want to Upgrade. |
DSP Downgrade Procedure
DSP Downgrade procedure is exactly same as that of DSP Upgrade procedure. Please refer to DSP Upgrade procedure in order to check for DSP downgrade process too.
...