IMG 1010 - Bearer Capabilities Override

Description:

The Bearer Capabilities are part of the Q.931 SETUP messages and define the characteristics of a call. The Bearer Capability parameter used by the calling party specifies the B-Channel that is being requested. The Bearer Capabilities Override pane will configure the IMG to either pass-through (ignore) the bearer capability or change it to a pre-selected parameter from drop down menu.

Accessing this Pane:

Dialogic IMG EMS -> Routing Configuration -> Channel Groups-> Channel Group (ISDN) -> ISDN Group -> Bearer Capabilities Override

Maximum Objects:

1 per ISDN ISUP Group

ClientView Pane:

Field Descriptions:

Coding Standard:

Ignore (default)- Propagate the Coding Standard to the Outbound SETUP message.

CCITT (ITU-T)- Change the Coding Standard to CCITT in the Outbound SETUP message.

ISO/IEC Standard- Change the Coding Standard to ISO/IEC in the Outbound SETUP message.

National standard- Change the Coding Standard to National Standard in the Outbound SETUP message.

Standard for Network side of interface- Change the Coding Standard to Standard for Network Side of Interface in the Outbound SETUP message.

Information Transfer Capability:

To set the Information Transfer Capability you must also set the Coding Standard to a value other than Ignore.

Ignore (default)- Propagate the Informational Transfer Capability to the Outbound SETUP message.

Speech- Change the Information Transfer Capability to Speech in the Outbound SETUP Message

Unrestricted Digital Info- Change the Information Transfer Capability to Unrestricted Digital Info in the Outbound SETUP Message

Restricted Digital Info- Change the Information Transfer Capability to Restricted Digital Info in the Outbound SETUP Message

3.1 kHz audio- Change the Information Transfer Capability to 3.1 KHz audio in the Outbound SETUP Message

7 khz- Change the Information Transfer Capability to 7 KHz audio in the Outbound SETUP Message

Video- Change the Information Transfer Capability to Video in the Outbound SETUP Message

Transfer Mode:

Ignore (default)- Propagate the Transfer Mode to the Outbound SETUP message

Circuit Mode- Change the Transfer Mode in the Outbound Setup message to Circuit Mode

Packet Mode- Change the Transfer Mode in the Outbound Setup message to Packet Mode

User Information layer 1 protocol:

Ignore (default)- Propagate layer 1 protocol to the Outbound SETUP Message

G.711 u-law- Change the layer 1 protocol to G.711 u-law in the Outbound SETUP Message

G.711 A-law- Change the layer 1 protocol to G.711 A-law

G.721- Change the layer 1 protocol to G.721 in the Outbound SETUP Message

H.221 and 242- Change the layer 1 protocol to H.221 and H.242 in the Outbound SETUP Message

H.223 and 245- Change the layer 1 protocol to H.223 and H.245 in the Outbound SETUP Message