On this page you can set user specific settings for users you have access to.
Should Find Me/Follow Me be enabled for this user
List extensions to ring, one per line. You can include an extension on a remote system, or an external number by suffixing a number with a pound (#). ex: 2448089# would dial 2448089.
Message to be played to the caller before dialing this group.
This is the number of seconds to ring the primary extension prior to proceeding to the follow-me list. The extension can also be included in the follow-me list. A 0 setting will bypass this.
Time in seconds that the phones on the follow me list will ring. The number of rings will depend on region. Example: If a phone rings for 1 second then waits 2, each ring is 3 seconds.
Enable this if you're calling external numbers that need confirmation - eg, a mobile phone may go to voicemail which will pick up the call. Enabling this requires the remote side push 1 on their phone before the call is put through. Example "Press 1 to accept.
Message to be played to the person RECEIVING the call, if 'Confirm Calls' is enabled
Message to be played to the person RECEIVING the call, if the call has already been accepted before they push 1.
Weather or not to forward calls in a given state. Check the box and enter the destination in the text field.
Number of seconds to ring prior to going to voicemail or other fail over destinations that may be setup by an administrator on this account. The Always setting will ring the call forward destination until answered or the caller hangs up. The Default setting will use the value set in Ring Time. Your setting here will be forced to Always if there is no Voicemail or alternative fail over destination for a call to go to.
Forward calls immediately regardless of current state of line/PBX to the number entered.
Preconfigured number to which calls are forwarded if the customer endpoint becomes unresponsive due to an Internet outage or software/configuration failure of endpoint
Preconfigured number to which calls are forwarded if the customer endpoint is busy, usually due to being on an active call
Used to indicate that this user does not wish to be disturbed.
A weather this user making a telephone call should be notified of an incoming call and is able to place the first call on hold while answering the second.
All settings are updated and applied in real time. No need to press save.