Dialogic IMG - IMG 1010 - GCEMS Installation Script for 10.5.2
The example script below displays the installation of the GCEMS software.
10.5.x_xxx GCEMS Software
[root@kthomas ftpBuilds]# ./IMG\_10.5.2.42.bin |
Preparing to install...
Extracting the JRE from the installer archive...
Unpacking the JRE...
Extracting the installation resources from the installer archive...
Configuring the installer for this system's environment...
Launching installer...
Preparing CONSOLE Mode Installation...
===============================================================================
IMG (created with InstallAnywhere by Macrovision)
-------------------------------------------------------------------------------
===============================================================================
Introduction
------------
InstallAnywhere will guide you through the installation of Dialogic IMG 1010
Integrated Media & Signaling Gateway 10.5.2.42.
It is strongly recommended that you quit all programs before continuing with
this installation.
Respond to each prompt to proceed to the next step in the installation. If you
want to change something on a previous step, type 'back'.
You may cancel this installation at any time by typing 'quit'.
PRESS <ENTER> TO CONTINUE:
===============================================================================
System Configuration
--------------------
Is this going to be a redundant system? (Default=No...Select 'Yes' if there will be GCEMS redundancy otherwise select 'No')
1- YES
->2- NO
ENTER THE NUMBER FOR YOUR CHOICE, OR PRESS <ENTER> TO ACCEPT THE DEFAULT:
: 2
===============================================================================
Pre-Installation Summary
------------------------
Please Review the Following Before Continuing:
Java VM Installation Folder:
/jre
Product
GateControlEMS
Install Folder
/opt/dialogic/IMG
PRESS <ENTER> TO CONTINUE:
===============================================================================
Get User Input
--------------
A previous configuration has been detected. Do you want to backup the configuration?
->1- Yes (Default=Yes... See "Additional Information" heading below that explains the selections)
2- No
ENTER THE NUMBER FOR YOUR CHOICE, OR PRESS <ENTER> TO ACCEPT THE DEFAULT:
: 2
===============================================================================
Installing...
-------------
[==================|==================|==================|==================]
[------------------|------------------|------------------|------------------]
===============================================================================
Installation Complete
---------------------
Congratulations! IMG 10.5.2.42 has been successfully installed to:
/opt/dialogic
**********************************************************************
**********************************************************************
To properly run this product, you must
LOG OUT AND BACK IN
to set up your environment.
**********************************************************************
**********************************************************************
The following directories have been configured as NFS mountable:
/opt/dialogic/common/calltracing
/opt/dialogic/common/treatments/datafiles
/opt/dialogic/common/routing/sending
NOTE: The NFS service should be restarted after this installation completes
**********************************************************************
**********************************************************************
Press "Enter" to continue.
PRESS <ENTER> TO EXIT THE INSTALLER:
[root@kthomas ftpBuilds]#
Enter exit command to update /etc/profile
[root@kthomas ftpBuilds]# exit
[excelsw@kthomas ftpBuilds]$ |
Additional Information:
Restart NFS:
To restart NFS enter:
#/sbin/service restart nfs |
Get User Input from Above:
This section of the install is relevant only if this GCEMS server had previously configured an IMG or Network of IMG's.
Default = Selection = Yes:
If this GCEMS server had previously configured an IMG then there will be the following files in the /opt/dialogic/common/config directory:
system.cfg
XML
If the default, which is Yes, is accepted then the files above would have been backed up into a folder named config_backup_<timestamp>. This file is created so a backup of all pertinent files is created.
Selection = No:
This is recommended only when performing an upgrade of software to an SS7 Network of IMG's and the feature Gracefully Upgrade IMG software in SS7 network is being performed. Otherwise go with the default.