Dialogic Media Gateway - What port-specific argument to use when configuring DMG2000 via serial port
Introduction
This article provides clarification on how to specify the port in commands that are issued when using the serial port on a Dialogic® 2000 Media Gateway (DMG2000 Gateway).
Details
The DMG2000 Gateways allow a user to issue commands when a serial port cable is attached to the unit. In general, the commands will set or get information for all the ports on the DMG2000 Gateway. If the user wants to get or set information on a single port of the unit, he or she can append the port # to the command. The following are examples where the port # (highlighted in yellow) has been appended to the command:
Queries whether port #1 is activated
cfg get telPortEnabled Port1
Disables port #2
cfg set telPortEnabled Port2 No
Sets port #4 as Network Terminated
cfg set telPortInterfaceSide Port4 Network