/
Phones - How To Configure WiFi On The Sangoma P370 Phone

Phones - How To Configure WiFi On The Sangoma P370 Phone

The following article will explain how to enable and configure Wi-Fi on the Sangoma P370 desk phone. The phone MUST be on firmware version 4_9_2 or later to have access to the Wi-Fi settings.

 

Enabling On Already Configured P370

If the P370 has already been configured it will need to be reconfigured to access the Wi-Fi settings. 

  1. Press the settings button in the upper left corner. (The three horizontal lines)

  2. Press the Advanced menu option

  3. Press the Reconfigure menu option

  4. Once this option is selected it will go into the normal settings menu like an unconfigured phone.

**Note: This will not cause the P370 to lose it's existing extension configuration. 

wifi1.jfif

 

 

 

 

Configuring The Wi-Fi Settings

While in the settings menu, tap the Network Settings option. 

wifi2.jfif

 

 

 

Tap the Wi-Fi Settings option. 

 

 

 

Swipe the Wi-Fi toggle from left to right to enable.

 

 

 

Once the Wi-Fi toggle is enabled, the P370  will open up the section below and start scanning for available networks. 

  • If your Wi-Fi SSID is broadcast, select it from the available networks, enter the associated password at the bottom, then select submit. 

  • if your Wi-Fi SSID is not broadcast, enter it manually into the SSID field, enter the associated password at the bottom, then select submit. 

The phone will now update the configuration and reboot. 

 

 

 

After the phone reboots and is configured you will now see the Wi-Fi symbol at the top of the screen.

 

Related content

Return to Documentation Home I Return to Sangoma Support