/
Sangoma Talk mobile with PBXact Cloud

The following content only applies to FreePBX and PBXact platforms

Sangoma Talk mobile with PBXact Cloud

Creating this document to give an idea about how to configure the Sangoma connect on the freshly installed FreePBX/PBXact Cloud.

  1. Make sure the Sangoma connect module is installed on your PBX , if module not installed then refer the below link and install the module.

  1. Run Register Domain.

Navigate to Admin ==> Sangoma Connect==> Run Domain Action ==>Register domain.

  1. Run Update certificates.

    1. Go to Run Domain Action and update the certificates

  1. Press Enable Sangomaconnect to start the sangoma connect service.

  1. Enable Sangoma connect for the users.

    1. Refer the below link to enable Sangoma connect for users.

 

 

Related content

Installing Sangoma Talk for Mobile
Installing Sangoma Talk for Mobile
More like this
Phones - Connecting Sangoma Phone to FreePBX or PBXact Indepth
Phones - Connecting Sangoma Phone to FreePBX or PBXact Indepth
More like this
Softphones - How to Setup Sangoma Phone Desktop on the PBX
Softphones - How to Setup Sangoma Phone Desktop on the PBX
More like this
SBC configuration for Sangoma Talk mobile
SBC configuration for Sangoma Talk mobile
More like this
Phones - FreePBX or PBXact Administration
Phones - FreePBX or PBXact Administration
More like this
Connecting Sangoma Phones
Connecting Sangoma Phones
More like this

Return to Documentation Home I Return to Sangoma Support