...
Any line beginning with the # symbol is a comment and is not processed by the IMG 1004. Below is the information the user will edit for use in its network
yiaddr --> IP Address of the IMG 1004 being loaded
subnetmask --> Subnet mask of the IMG 1004 being loaded
giaddr --> IP Address of the Gateway connected to the IMG 1004
file --> If using the SD card to supply boot information but loading the software from the FTP Server, the System Software Filename on the bootup.cfg file should be given a path to the IMG System Software file located on the ftp server. The default path is /home/excelsw/ftpBuilds or ftpBuilds/ as the IMG 1004 logs into the FTP server using the excelsw account.
Host flag --> The Host Flag informs the IMG of configuration details such as T1 or E1, Boot from SD card or Boot from FTP Server, and a few other configuration details. See IMG 1010 - Setting Host Flags.
siaddr --> IP Address of FTP server which provides the IMG 1004 System Software and NTP Server information
sname --> Optional, not currently used. Do not edit this
Change the Host Flag to "Retrieve IMG Build from SD Card".
Host Flag Values
...
Edit the bootup.cfg file to reflect the new Host Flag value
Edit the System Software Filename in the bootup.cfg file to reflect the new software file being loaded. (Ex: file=/excelsw/ftpBuilds)
Edit the rest of the bootup.cfg file to reflect your network values.
Save the bootup.cfg file
Remove the SD card from the SD Writer.
Insert the SD card into the SD slot on the Front Panel of the IMG.
Power-up the IMG 1004.
The IMG 1004 will go through a diagnostic check and then load software. See IMG 1004 - Front Panel Status LEDs for more information on the boot process.
Once the loading of software and configuring of network information is complete, the IMG 1004 will be ready to get configured