...
Right Click on the IMG Name (Physical IMG) and select New Network. From this object, the interfaces on rear of IMG can be configured. In this procedure, the DATA interface which will interface with the VoIP module will be configured. See IMG 1010 - IP Network (Interface) for more information on the IP Network element. If using an older build then see IMG 1010 - Configuring VoIP
Right Click on IP Network just created and select New IP address. Select VoIP Module from drop down menu in the Physical Interface field and leave the Logical Interface as Data if using the Data Port on rear of IMG. See IMG 1010 - IP Address for more information on populating this object. If using an older build, see IMG 1010 - Configuring VoIP.
Configure IP Bearer Profiles. See IMG 1010 - Configuring IP Bearer Profiles.
Create IP Bearer Facility:
Right Click on IMG Name and select New Facility. See IMG 1010 - Facility link for more information.
Right Click on Facility and select New Bearer - IP. See IMG 1010 - VoIP Resource for more information.
Create H323 Signaling Stack:
Right-click External Elements and select New External Gateways
Right-click External Gateways and select New External Gateway
Below is screen capture from ClientView of H.323 Gateway
Name- Enter a name that describes this particular external/remote H.323 Gateway.
Gateway Signaling Protocol- Select H323 from drop down menu
Gateway Address Type- This field defaults to 'Gateway IP Address'. The remote H.323 gateway can be identified with IP address only.
Gateway IP Address- Click in field and enter IP address of the external/remote H.323 gateway in the 'Enter IP Address' box that appears.
Gateway Mask- Click in field and enter an address mask. This can be used to validate a range of IP addresses for multiple GW's.
Gateway Remote Port- Default Port is 1720 and cannot be changed.
...
Gateway Host Name
Gateway Transport Type
Gateway Registration Required
Registration Expiration Interval
SIP Profile
Options Keep Alive