B700 Hybrid Telephony Card
...
View Datasheet
Installation Manual -
View file | ||
---|---|---|
|
Table of Contents |
---|
Overview
...
-> NT Power Adapter "SPEC-BNPWR1" - More Info
When using FXS modules, an internal 12V power to A200 main board is required. Use 4-pin Molex power connector from server power supply
...
The resistors corresponding ports 1 and 2 are closest to the PCI base.
The ON position is closer to the NT/TE modules.
The OFF position is closer to the RJ-45 connectors.
FXO/FXS Module Installation
Slide the module into the main card until they click in properly. You should be able to read the designation FXO or FXS on the outside of the card (Remora) after installation.
...
FXO modules are RED in color
FXS modules are GREEN in color
...
How to Connection PSTN lines to A500:
...
Telephony card installation is very simple:
Power off server and remove cover to access the PCI/PCIexpress slots
Identify the PCI/PCIexpress slot to be used for your telephony card
Remove the backplate for that slot, from the server.
This backplate may require screwdriver to remove screws before pulling off the backplate. Use your discretion
Insert the telephony card into the PCI/PCIexpress slot and verify it is firmly seated
With the faceplate lines up with the mounting bracket, screw it firmware in place.
verify the E1/T1 ports are lined up and fully accessible from the back of the server before securing position
Plug in your E1/T1 cables into the telephony card
if you are unsure of the pinouts, see below for details
Place server cover back on and power on
BRI Cable Wiring
...
Software Installation
Select your Installation type: