...
Command: wanpipemon -i w1g1 -c Ta
Note: Can be run for any wanpipe interface listed in "ifconfig" (refer to Glossary below)
More information is located on Wanpipe Alarm Statistics page
Errors
Rx Level
must be -2.5db
If Rx Level is not -2.5db there is a cable issue
Line, Bit and Out of frame errors.
Make sure they are not incrementing.
If incrementing, the clock on the T1/E1 line is bad.
One can try to configure wanpipe port to MASTER clock.
However the telco is suppose to provede the clock
...
Overrun statistics are described in Wanpipe Debugging Section
Glossary
Wanpipe Interfaces
...