Getting Started with the DC201
This guide will walk you through configuring your new Sangoma DC201 DECT phone set and (optionally) additional D10M Handsets.
...
Click "Save Basestation" and navigate to Extension Mapping using the navigation menu on the right.
...
Adding an Extension and Handset to a DECT Basestation in Endpoint Manager
...
Extension - The extension that will be used for a given handset.
Brand - Sangoma, of course!
Model - As this time, the DB20 is the only model of Sangoma base station supported
Base station - The base station you created in the previous step.
...
Select "Save and Rebuild Config(s)" and click "Use Selected".
...
The IPEI is a 10-character unique identifier for a handset.
Each handset IPEI must be programmed into the base station to pair the units.
Each handset'sIPEI can be found in 3 places:
On the label of the handset box; or
By navigating your handset to Settings > Status; or
By removing the battery cover on the back of the handset - the IPEI is on a label under the two removable batteries. (Note: the handset's Serial Number is also located there).
All other values will have been previously configured.
IPEI SHOWS IN THE SAME FORMAT AS MAC ADDRESS SO MAKE SURE TO REMOVE THE : BETWEEN CHARACTERS
...
Select "Save and Rebuild Config(s)" and click "Apply".
...
Via the Sangoma Redirect Service
Via the DECT basestation web GUI
Navigate to http://IPaddress/, where IPaddress is the IP address of your basestation.
By default, the username/password is: admin/admin.
The password can be configured under Endpoint Manager > Global Settings > Phone Admin Password
Sangoma strongly recommends that you change the default username and password for security purposes
Navigate to Management
...
Set the following options:
Management Transfer Protocol - HTTP or HTTPS. HTTPS is preferred, but requires additional configuration on the PBX. (Note that to obtain the HTTP Management passwords with FreePBX as described below requires the SysAdmin Pro commercial module, which is included with PBXact. Also, this is not needed if you only use EndPoint Manager to configure the phone).
HTTP Management username - The username from Sysadmin > Provisioning Protocols
HTTP Management password - The password from Sysadmin > Provisioning Protocols
Configuration File Download - "Base Specific File"
Configuration Service Address - The IP address and port of your PBX provisioning service. e.g. 192.168.0.35:84 or 192.168.0.35:1443
Leave all other configuration options at their default values.
...
Click "Save and Reboot"
Your basestation will now reboot and pull a configuration from the PBX.
This process may take a few minutes.
...