IMG 1010 - DS3 Physical Span - 10.3.x

DS3 Physical Span (IMG 1010 Only) (10.3.3 Software and below only)

Description:

Use this pane to configure a DS3 span.

 Accessing this Pane:

Dialogic IMG EMS -> Logical IMG -> Physical IMG -> Facility -> TDM DS3 -> DS3 Physical Span

Maximum Objects:

1 DS3 per Physical IMG. 1 DS3 = 28 DS1's

Related Topics:

IMG 1010 - Configuring a Range of DS3 - 10.3.x

IMG 1010 - DS3 Physical Span Configuration - 10.3.x

ClientView Pane: (10.3.2 and below):

ClientView Pane: (10.3.3):

Field Descriptions:

Offset:

The physical span getting configured. ClientView will allow the creation of 1 DS3 which is 28 DS1's. Offsets 0-27

Loop Timing Type:

This field is a drop down menu. This field specifies whether Primary Loop, Secondary Loop, or Not Timing Source will be configured on this offset. The drop down menu choices are shown below

• Primary

• Secondary

• Not Timing Source

Framing:

Specifies whether the framing of the span is ESF or D4.

• ESF (Extended Super Frame)

• D4

Signaling:

Specifies whether signaling will CAS where the signaling for each channel is directly associated with that channel or will be Clear Channel where one channel is used to carry signaling for all other channels

• Clear Channel

• CAS (Channel associated signaling)

Line Coding:

Specifies the line coding of T1 span. E1 line

• AMI (T1)

• Bit 7 zero suppressing (T1)

• B8ZS zero suppressing (T1)

• HDB3 (E1)

DS3 Loopback Mode:

Enable local or remote loopback with the DS3 Loopback Mode field. To allow loop-back to be configured from the far-end, enable the DS3 and DS1 FEAC Responses option in the Bearer DS3 id:0 ClientView pane.

• No loopback

• Local Loopback

• Remote Loopback