Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

Single port PPP Configuration

For a single PPP link use Wanpipe PPP stack.

Wanpipe Installation

  1. Download latest STABLE wanpipe release
    -->wanpipe-7.0.24.tgz

  2. Untar wanpipe release
    --> tar xfz wanpipe-<ver>.tgz

  3. Install wanpipe release
    --> cd wanpipe-<ver>
    --> ./Setup install 
          Use all default options

  4. Confirm successful install
    --> wanrouter version
    --> wanrouter hwprobe

 

Configuration

Run wanpipe configuration utility:

/usr/sbin/wancfg

Hardware Setup (AFT):

Select Hardware: Specify AFT card from hardware probe.

    After hardware probe,  wancfg screen should show  you:
    (in case of A104 card)
    ----------------------------
    Card Type-------> A104    
    Physical Medium-> T1    
    ----------------------------

Sepecify Line Type:  T1 or E1
                                 Default is T1 

Default configuration is complete: Select <BACK>

Protocol Setup:

Select Protocol: PPP

Configuration is complete: Select <BACK>

Interface Setup:

Skip First option and leave it default.

Select: Operation Mode
            WANPIPE

Select: IP Address Setup
            Local IP addr: Set this local IP Address
            Point-to-Point IP Address: Set this to the ip address of the remote side

Select: Default Gateway
            Leave it to no if you do not want the PPP interface to be your default route.
            Set this to yes, and enter your Gateway IP Address if you want packets to go to the PPP interface by default.

Configuration is complete: Select <BACK> to Save and Exit

After a wanrouter start, your PPP interface will come up as w*g1ppp. (for example w1g1ppp)

Operations

  • Start all wanpipe ports

    • wanrotuer start  #Start all wanpipe ports defined in /etc/wanpipe/wanrouter.rc

  • Start a single port

    • wanrouter stop   

  • Logs

    • /var/log/messages

  • Config directory

    • /etc/wanpipe

Debugging

  • wanpipemon utility

    • wanpipemon <enter> for help

  • T1/E1 Alarm Statistics

    • wanpipemon -i w1g1 -c Ta

More Info

Troubleshooting & Diagnostic commands

Multi-Link PPP Configuration

Multi-Link PPPD

  • No labels