A142 Installation

A142 Data Telephony Card

View Datasheet  
 

Overview

• Two full-speed primary ports supporting either V.35/RS422/EIA530 or RS232 serial interfaces

• High-speed connections: V.35/RS422/EIA530 to 8 Mbps per port. RS232 to 400 kbps per port

• Power: 550 mA at +5 V

• PCI Versions are 32 bit (5 V) and 64 bit (3.3 V) compatible

• Now available in PCI or PCI Express

• Operating temperature range: 0 – 50°C

• Software configurable or by machine BIOS

• Dimensions: 2U Form factor: 120 mm x 55 mm for use in restricted chassis
  

Hardware Installation

Compatibility Note 

Sangoma Telephony cards are designed to be compatible with most commercially available motherboards.

PCI details

• Autosense compatibility with 5 V and 3.3 V PCI buses

• Maximum operational power for PCI: 3 W (0.6 A @ 5 V) For PCI Express: 2.5 W (0.76 A @ 3.3 V)

PCI-Express details

• 1 Lane PCI Express bus

• Compatible with 4x, 8x and 16x slots

Faceplate

Sangoma Telephony cards ship pre-installed with 1 U faceplate, along with a 2 U faceplate as accessory.

If you have a 2 U server, the 1 U faceplate will need to be removed to install the 2 U faceplate.
If this is your case, please view the following Demo which indicates which screws to remove and how to separate the card 

Telephony card installation is very simple:

1. Power off server and remove cover to access the PCI/PCIexpress slots

2. Identify the PCI/PCIexpress slot to be used for your telephony card

3. Remove the backplate for that slot, from the server. 

   1. This backplate may require screwdriver to remove screws before pulling off the backplate. Use your discretion

4. Insert the telephony card into the PCI/PCIexpress slot and verify it is firmly seated

5. With the faceplate lines up with the mounting bracket, screw it firmware in place.
   

6. Place server cover back on and power on

Cable Pinouts

Software Installation

Select your Installation type:

• Install with API