IMG 1010 - Connecting Ethernet and TDM Cables
Â
CAUTION: Routers or switches connected to the IMG 1010 should be configured for 100Mbit and Auto-negotiation. Disabling auto-negotiation may result in packet loss. Also, broadcast propagation between ports must be enabled to allow BootP.
Â
Network Interface Ports
There are three types of Network Interface ports on the IMG 1010:
Control (Network Management)
Data (RTP)
Signaling (SIP and H.323)
The IMG 1010 supports a variety of scenarios for designing your IP network. In this example, the Network Management is connected to CTRL 0 and the VoIP interfaces to DATA 0. These can be on either the same or different subnets.
For information on the various scenarios supported, see IMG 1010 - Network Interface Scenarios.
Â
TDM Bearer Channels and SS7 Signaling
In this example scenario, the Bearer ports are used for both bearer and signaling. Your SS7 Signaling can also be brought into the SIGNAL/TIMING port.
Â
Related Topic:
IMG 1010 - RJ 48 Connector Pinouts
Â
Â