IMG 1004 - I/O Cable Specifications
Â
CAUTION: Sangoma recommends that you configure any routers or switches connected to the IMG 1004 for 100Mbit and Auto-negotiation. Disabling auto-negotiation may result in packet loss. Also, broadcast propagation between ports must be enabled to allow BootP.
Â
Overview
The IMG 1004 can be interconnected in a single platform configuration or in a redundant platform configuration.
Â
10/100BaseT Ethernet Cable Specifications
The IMG 1004 communicates with the host and other units in the network through Ethernet connections over:
10BaseT
100BaseT
Â
The table below lists the cable specifications.
Characteristics | 10/100Base-T (Shielded) Category 5 |
---|---|
Designator | Twisted pair |
Segment Length - Recommended maximum | 100 meters (328 ft) |
Cable Type | 100-Ohm shielded twisted pair |
Connector | 8-pin RJ-45 |
Â
T1/E1 Span/Timing Cable Specifications
The tables below list the cable specifications.
Characteristics | T1 (Shielded) Category 8 |
---|---|
Designator | Twisted pair |
Segment Length - Recommended maximum | 100 meters (328 ft) |
Cable Type | 100-Ohm shielded twisted pair |
Connector | 8-pin RJ-48 |
Â
Characteristics | E1 (Shielded) Category 8 |
---|---|
Designator | Twisted pair |
Segment Length - Recommended maximum | 100 meters (328 ft) |
Cable Type | 120-Ohm shielded twisted pair |
Connector | 8-pin RJ-48 |
Â