IMG 1010 - Adding a Physical IMG
Â
Â
Related Topics:
IMG 1010 - Configuration Wizard
IMG 1010 - Monitoring the IMG Using ClientView
Procedure:
Right-click on the Logical IMG object created and select New Physical IMG. The Physical IMG Object will get created:
The IMG ID field will be automatically populated with the next ID.
In the IMG Name field, enter a name that will identify this specific IMG.
In the IP Address field, enter the IP Address of this Physical IMG. This is the same IP Address assigned to the CTRL 0 port on the back of the IMG.
The IP Address entered in step 4 is the IP address assigned to the CTRL 0 port on the IMG.
The IMG Type field will be automatically populated with either 1004 or 1010 dependent on whether the node being configured is an IMG 1010 or IMG 1004.
The Trunk Type field will also be automatically populated with T1 or E1 dependent on whether the node being configured is using T1 or E1 protocol.
Next Topics
IMG 1010 - Network Interface Scenarios
IMG 1010 - Configuring Network Interfaces
Physical IMG Pane (10.3.3)
Â