Introduction

The following Dialogic Eiconcard™ boards require the use of the drivers "Eiconcard Connections for Windows" which are available via our product page
http://www.wiki.sangoma.com/Products/serial-protocol-adapters/eiconcards/eiconcard-connections-for-windows.aspx

• C30

• C31

• C90

• C91

• CX1

• S92

• S94 8MB (Part number - 310-208-03)

Installation

The following installation was carried out using an S91 card.

The S91 card will appear as a 'Network Adapter' entry in Device Manager.

Open

Using the WAN Services Configuration Program

Start the Eiconcard configuration program by any of the following methods:

• Running ECADMIN at a command prompt (use full path of <drive:>\winnt\system32\eicon)

• From Start > Programs > Dialogic > Eicon Cards > Eicon Configuration Program

• From the 'Advanced Properties' of the Eiconcard in Device Manager

After loading you will see:

Open

Step 2. Configure the Eiconcard adapter options according to your requirements. Then click on a card icon to show high level protocols and ports.

Step 3. Configure the high level protocols as required.

Step 4. Configure each of the ports as required.

Step 5. After finishing configuring all the ports, select the "Save" option form the File menu and then "Exit" to complete the Core Services Configuration.