/
Session Border Controller - Generating SBC License Files

Session Border Controller - Generating SBC License Files

Before generating your license files ensure you've received a license key from sales. 

  1. Go to http://prod-license.sangoma.com/nsc-license-gen/ to visit the license file generation page.

  2. For appliances you will need to get your hard disk serial number using the command below. For VM SBC's you will need to use your MAC address using the command below. These commands need to be ran on the Linux CLI of your SBC.

    Appliance (hard disk serial number) Command:     sudo hdparm -I /dev/sda | grep -i serial

    VM's (Mac Address) Command:     ifconfig | grep -i hwa

  3. Copy/paste the hard drive serial number or MAC address into the license file generation page. 

  4. Enter the key given by the license key from the sales team into the license file generation page.

  5. Press submit on the page and your license files will be generated. To download your license click on the provided URL. 

 

Uploading License to the SBC

  1. Once the license file is downloaded, you can upload it to the SBC by going to System→Settings→ License and then clicking the Upload button, as shown below. 

 

 

Related content

Session Border Controller - Generating SBC License File
Session Border Controller - Generating SBC License File
More like this
Session Border Controller - Software SBC installation
Session Border Controller - Software SBC installation
More like this
Dialogic IMG - Licensing (SBC Mode)
Dialogic IMG - Licensing (SBC Mode)
More like this
Support Services - Session Border Controllers (SBC)
Support Services - Session Border Controllers (SBC)
More like this
Session Border Controller - First Boot & Initial Setup
Session Border Controller - First Boot & Initial Setup
More like this
Session Border Controller - Factory Configuration
Session Border Controller - Factory Configuration
More like this

Return to Documentation Home I Return to Sangoma Support