GSM W400 Installation

Owned by Nathaniel Halbrooks
Last updated: Feb 07, 2024 by Kelli Higdon
2 min read

 

This Product has been discontinued. For full details please visit the Sangoma EOL Notice Page

 

 

GSM W400 Telephony Card

View Datasheet

Overview

  • GSM board that supports 1 to 4 GSM modules.

  • Supports Asterisk® .

  • Quad-Band.

  • Wanpipe Driver which includes a suite of configuration, operation and debugging utilities

Hardware Installation

Compatibility Note 

Sangoma Telephony cards are designed to be compatible with most commercially available motherboards.

PCI details

  • Autosense compatibility with 5 V and 3.3 V PCI buses

  • Maximum operational power for PCI: 3 W (0.6 A @ 5 V) For PCI Express: 2.5 W (0.76 A @ 3.3 V)

PCI-Express details

  • 1 Lane PCI Express bus

  • Compatible with 4x, 8x and 16x slots

 

Telephony card installation is very simple:

  1. Power off server and remove cover to access the PCI/PCIexpress slots

  2. Identify the PCI/PCIexpress slot to be used for your telephony card

  3. Remove the backplate for that slot, from the server. 

    1. This backplate may require screwdriver to remove screws before pulling off the backplate. Use your discretion

  4. Insert the telephony card into the PCI/PCIexpress slot and verify it is firmly seated

  5. With the faceplate lines up with the mounting bracket, screw it firmware in place.

    1. verify the E1/T1 ports are lined up and fully accessible from the back of the server before securing position

  6. Plug in your E1/T1 cables into the telephony card

    1. if you are unsure of the pinouts, see below for details

  7. Place server cover back on and power on

 

Hardware Configuration

Software Installation

Select your Installation type:

Return to Documentation Home I Return to Sangoma Support