IMG 1010 - Front Panel Status LEDs

Each LED consists of two separate LEDs (red and green). The bi-colored LEDs can be selected to be red, green, orange (both red and green on) or blinking of any of the colors. All LEDs are under software control.

POWER LED

This LED that indicates power status. The green LED is hard wired to 3.3V while the orange LED is under software control.

ALARM LED

This LED indicates alarm conditions.

SIG/TIMING LED

These four LEDs indicate T1/E1 spans statuses for the SIGNAL/TIMING 0, 1, 2, 3 connectors.

TIMING LED

This LED indicates whether the system timing is free running, locked on an external timing source or in hold over (lost lock on external timing source, but still synched to it).

ENET CTRL LED

These two LEDs indicate link and master control of the Ethernet control plane via the CTRL 0 and CTRL 1 connectors. The mastership is controlled via software while the link is under hardware control.

ENET DATA LED

These two LEDs indicate link and master control of the Ethernet data plane via the DATA 0 and DATA 1 connectors. The mastership is controlled via software while the link is under hardware control.

ENET SIG LED

These two LEDs indicate link and master control of the Ethernet signaling plane via the SIG 0 and SIG 1 connectors. The mastership is controlled via software while the link is under hardware control.

AUX LED

These LEDs are reserved for future use.

SPAN STATUS LED

These 28 LEDs indicate the bearer span (0 - 27) statuses. For DS3, each span has it's own LED.