This Product has been discontinued. For full details please visit the Sangoma EOL Notice Page
GSM W400 Telephony Card
Overview
GSM board that supports 1 to 4 GSM modules.
Supports Asterisk® .
Quad-Band.
Wanpipe Driver which includes a suite of configuration, operation and debugging utilities
Hardware Installation
Compatibility Note
Sangoma Telephony cards are designed to be compatible with most commercially available motherboards.
PCI details
Autosense compatibility with 5 V and 3.3 V PCI buses
Maximum operational power for PCI: 3 W (0.6 A @ 5 V) For PCI Express: 2.5 W (0.76 A @ 3.3 V)
PCI-Express details
1 Lane PCI Express bus
Compatible with 4x, 8x and 16x slots
Telephony card installation is very simple:
Power off server and remove cover to access the PCI/PCIexpress slots
Identify the PCI/PCIexpress slot to be used for your telephony card
Remove the backplate for that slot, from the server.
This backplate may require screwdriver to remove screws before pulling off the backplate. Use your discretion
Insert the telephony card into the PCI/PCIexpress slot and verify it is firmly seated
With the faceplate lines up with the mounting bracket, screw it firmware in place.
verify the E1/T1 ports are lined up and fully accessible from the back of the server before securing position
Plug in your E1/T1 cables into the telephony card
if you are unsure of the pinouts, see below for details
Place server cover back on and power on
Hardware Configuration
Software Installation
Select your Installation type: