IMG 1010 - GCEMS Installation Script

Owned by Kelli Higdon
Dec 14, 2023
2 min read

IMG 1010 - GCEMS Installation Script

 

The example script below displays the installation of the GCEMS software.

 

10.5.x_xxx GCEMS Software

[root@kthomas ftpBuilds]# ./IMG\_10.5.1.103.bin
Preparing to install... Extracting the JRE from the installer archive... Unpacking the JRE... Extracting the installation resources from the installer archive... Configuring the installer for this system's environment... Launching installer... Preparing CONSOLE Mode Installation... =============================================================================== IMG (created with InstallAnywhere by Macrovision) ----------------------------------------- =============================================================================== Introduction ------ InstallAnywhere will guide you through the installation of Dialogic IMG 1010 Integrated Media & Signaling Gateway 10.5.1.103. It is strongly recommended that you quit all programs before continuing with this installation. Respond to each prompt to proceed to the next step in the installation. If you want to change something on a previous step, type 'back'. You may cancel this installation at any time by typing 'quit'. PRESS <ENTER> TO CONTINUE: =============================================================================== System Configuration ---------- Is this going to be a redundant system? (Select 'Yes' if there will be GCEMS redundancy otherwise select 'No') 1- YES ->2- NO ENTER THE NUMBER FOR YOUR CHOICE, OR PRESS <ENTER> TO ACCEPT THE DEFAULT: : =============================================================================== Pre-Installation Summary ------------ Please Review the Following Before Continuing: Java VM Installation Folder: /jre Product GateControlEMS Install Folder /opt/dialogic/IMG PRESS <ENTER> TO CONTINUE: =============================================================================== Installing... ------- [==================|==================|==================|==================] [------------------|------------------|------------------|------------------] =============================================================================== Installation Complete ----------- Congratulations! IMG 10.5.1.103 has been successfully installed to: /opt/dialogic ************************************ ************************************ To properly run this product, you must LOG OUT AND BACK IN to set up your environment. ************************************ ************************************ The following directories have been configured as NFS mountable: /opt/dialogic/common/calltracing /opt/dialogic/common/treatments/datafiles /opt/dialogic/common/routing/sending * NOTE: The NFS service should be restarted after this installation completes ************************************ ************************************ Press "Enter" to continue. PRESS <ENTER> TO EXIT THE INSTALLER: [root@kthomas ftpBuilds]#

 

Enter exit command to update environment variables in  /etc/profile

[root@kthomas ftpBuilds]# exit [excelsw@kthomas ftpBuilds]$

Additional Information:

To restart NFS enter:    

#/sbin/service restart nfs

 

 

Return to Documentation Home I Return to Sangoma Support