FreeSWITCH D500 Selection

The D500 Transcoder has two methods of installation:

-> PCI Express connection
-> LAN Connection (RJ45)

The diagram below illustrates the connection methods

Open

Note: ->If using LAN connection, use only one of the RJ45 connectors.
             Do not plug in both RJ45 connectors to a network as it will
             cause a network loop. 
          -> LAN installation method is beneficial over PCI as Host CPU
              resources are not used (all RTP flows through LAN cable)

The installation steps below are prefixed with the installation method (PCI Express-, LAN-). 
Select one of the method which best suits  your environment

Single Server

-> PCI Express -> Installation
-> LAN              -> Installation

Distributed Server

1. PCI Express
   -> Core Installation  
   -> Sngtc Server Configuration
   -> Codec Module Configuration
   -> Operation

2. LAN
   -> Core Installation
   -> Sngtc Server Configuration
   -> Codec Module Configuration
   -> Operation

Find Below Block Diagrams illustrating the different parts of a transcoding environment

Figure 1: Sngtc Server hosting FreeSWITCH

• used for single server environment

• used as core server for distributed multi-server environment

Open

Figure 2: FreeSWITCH server hosting only codec module

when adding multiple FreeSWITCH servers in distributed environment

Figure 3: Single Server PCI Express D500 environment

Figure 4: Single Server LAN D500 environment

Figure 5: Distributed D500 Server Environment